sata_via issue for VIA Epia SP8000 in 2.6.18[.1]?

[Udo van den Heuvel <udovdh@xs4all.nl>]

Hello,

2.6.17.13 works OK on this VIA Epia SP8000.
(remember vaguely about some (PCI?) fixups to get things going)

Now I try to get 2.6.18.1 working. SATA is detected by this kernel but
disk gives timeout while 2.6.17.13 boots fine.

Some burbs:

Links is up but  SStatus 113 SControl 300
qc timeout (cmd 0xec)
failed to IDENTIFY
This results in a kernel panic.

Any ideas?

2.6.17.13 gives stuff like this:

scsi0 : sata_via
ata2: SATA link up 1.5 Gbps (SStatus 113)
ata2: dev 0 cfg 49:2f00 82:746b 83:7f01 84:4023 85:7469 86:3c01 87:4023
88:40ff
ata2: dev 0 ATA-7, max UDMA7, 312581808 sectors: LBA48
ata2: dev 0 configured for UDMA/133
scsi1 : sata_via
  Vendor: ATA       Model: SAMSUNG HD160JJ   Rev: ZM10
  Type:   Direct-Access                      ANSI SCSI revision: 05
SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
 sda: sda1 sda2 < sda5 sda6 sda7 sda8 sda9 sda10 >
sd 1:0:0:0: Attached scsi disk sda


Udo
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/