Re: [PATCH 1/2] [PCI] Check that MWI bit really did get set

[Matthew Wilcox <matthew@wil.cx>]

On Sat, Oct 14, 2006 at 01:48:55PM -0700, Andrew Morton wrote:
> On Sat, 14 Oct 2006 08:02:49 -0600
> Matthew Wilcox <matthew@wil.cx> wrote:
> 
> > On Fri, Oct 13, 2006 at 09:41:35PM -0700, Andrew Morton wrote:
> > > Bisection shows that this patch
> > > (pci-check-that-mwi-bit-really-did-get-set.patch in Greg's PCI tree) breaks
> > > suspend-to-disk on my Vaio.  It writes the suspend image and gets to the
> > > point where it's supposed to power down, but doesn't.
> > 
> > How odd.  What driver is calling pci_set_mwi() on the suspend path?
> 
> ehci_pci_reinit().  I stuck a dump_stack() in there.  See
> http://userweb.kernel.org/~akpm/s5000342.jpg

Thanks for the picture; that's really helpful.

I see.  We hibernate all the devices then wake them all back up again.
No doubt there's a good reason for this.

Still doesn't make much sense, though.  As far as I can see, the only
consequence of this particular patch is that 1) we do an additional read
from PCI_COMMAND and 2) we can return -EINVAL in one additional case.
But the only effect of returning EINVAL is a printk (for this particular
driver):

        /* PCI Memory-Write-Invalidate cycle support is optional (uncommon) */
        retval = pci_set_mwi(pdev);
        if (!retval)
                ehci_dbg(ehci, "MWI active\n");

        ehci_port_power(ehci, 0);

        return 0;

So even if we return EINVAL ... big deal.

Is it possible reading PCI_COMMAND too quickly after writing it causes
a foul-up?  That would be weird ...

so I suppose there's a few things I can ask you to try:

1. Stop reading the register back altogether.  This should revert the behaviour to the prepatch state:

-       pci_read_config_word(dev, PCI_COMMAND, &cmd);
+//     pci_read_config_word(dev, PCI_COMMAND, &cmd);

2. Put an mdelay(1); before that line

3. Change the last line to just return 0.

-       return (cmd & PCI_COMMAND_INVALIDATE) ? 0 : -EINVAL;
+	return 0;

> > What drivers do you have loaded on the Vaio?
> 
> sony:/home/akpm> lsmod

I don't see any of the other drivers calling pci_set_mwi, so i guess we're
looking at the right suspect.


I feel rather guilty about the amount of time you're spending on this;
any bugs you want me to look at as penance?
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/