From: Matthew Wilcox <matthew@wil.cx>

[Matthew Wilcox <matthew@wil.cx>]

We used to check whether pci_set_mwi() had succeeded by testing the
hardware MWI bit.  Now we need only check the return value (and failing
to do so is a warning).  Also, pci_set_mwi() will fail if the cache line
size is 0, so we don't need to check that ourselves any more.

Signed-off-by: Matthew Wilcox <matthew@wil.cx>

diff --git a/drivers/net/tulip/tulip_core.c b/drivers/net/tulip/tulip_core.c
index d11d28c..64d999b 100644
--- a/drivers/net/tulip/tulip_core.c
+++ b/drivers/net/tulip/tulip_core.c
@@ -1135,7 +1135,6 @@ static void __devinit tulip_mwi_config (
 {
 	struct tulip_private *tp = netdev_priv(dev);
 	u8 cache;
-	u16 pci_command;
 	u32 csr0;
 
 	if (tulip_debug > 3)
@@ -1153,21 +1152,15 @@ static void __devinit tulip_mwi_config (
 	/* set or disable MWI in the standard PCI command bit.
 	 * Check for the case where  mwi is desired but not available
 	 */
-	if (csr0 & MWI)	pci_set_mwi(pdev);
-	else		pci_clear_mwi(pdev);
-
-	/* read result from hardware (in case bit refused to enable) */
-	pci_read_config_word(pdev, PCI_COMMAND, &pci_command);
-	if ((csr0 & MWI) && (!(pci_command & PCI_COMMAND_INVALIDATE)))
-		csr0 &= ~MWI;
-
-	/* if cache line size hardwired to zero, no MWI */
-	pci_read_config_byte(pdev, PCI_CACHE_LINE_SIZE, &cache);
-	if ((csr0 & MWI) && (cache == 0)) {
-		csr0 &= ~MWI;
+	if (csr0 & MWI)	{
+		if (pci_set_mwi(pdev))
+			csr0 &= ~MWI;
+	} else {
 		pci_clear_mwi(pdev);
 	}
 
+	pci_read_config_byte(pdev, PCI_CACHE_LINE_SIZE, &cache);
+
 	/* assign per-cacheline-size cache alignment and
 	 * burst length values
 	 */
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/