Re: Tiny error in printk output for clocksource : a3:<6>Time: acpi_pm clocksource has been installed.

[Greg KH <greg@kroah.com>]

On Tue, Sep 26, 2006 at 08:54:15PM -0700, Randy Dunlap wrote:
> On Wed, 27 Sep 2006 02:36:58 +0200 Jesper Juhl wrote:
> 
> > On Wednesday 27 September 2006 02:33, Randy Dunlap wrote:
> > > On Wed, 27 Sep 2006 02:22:18 +0200 Jesper Juhl wrote:
> > > 
> > > > I get this in dmesg with 2.6.18-git6 :
> > > >       a3:<6>Time: acpi_pm clocksource has been installed.
> > > > 
> > > > Looks like some printk() somewhere is not adding \n correctly after
> > > > outputting a message priority or a message priority too much is
> > > > used... I've not investigated where this happens, but just wanted to
> > > > report it.
> > > 
> > > Hi,
> > > How about posting (pasting) some of the message log before that?
> > > 
> > Sure, below is the entire dmesg output from this boot of the box 
> > (including the line above) :
> 
> I suppose that you have CONFIG_PCI_MULTITHREAD_PROBE=y ?
> What happens if you change to to =n ?
> 
> > eth0: VIA Rhine II at 0xff5fec00, 00:50:ba:f2:<6>serio: i8042 AUX port at 0x60,0x64 irq 12
> > serio: i8042 KBD port at 0x60,0x64 irq 1
> > mice: PS/2 mouse device common for all mice
> > EDAC MC: Ver: 2.0.1 Sep 27 2006
> > TCP cubic registered
> > NET: Registered protocol family 1
> > NET: Registered protocol family 17
> > Starting balanced_irq
> > Using IPI Shortcut mode
> > a3:<6>Time: acpi_pm clocksource has been installed.
> > 1d, IRQ 18.
> > eth0: MII PHY found at address 8, status 0x782d advertising 01e1 Link 45e1.
> 
> I'm pretty sure that this is caused by parallel device probing.
> The serio and clocksource messages are interspersed with the
> eth0 (via rhine) info.  Garbled.
> 
> Greg, is this expected?

Only if one bit of code doesn't write a full line to the printk()
buffer, yes that could happen.

What driver writes "a3:"?  I couldn't find it anywhere in Linus's
current tree.

thanks,

greg k-h
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/