Re: [PATCH] ixgb: add PCI Error recovery callbacks

[Auke Kok <sofar@foo-projects.org>]

Linas Vepstas wrote:
> On Thu, Jul 06, 2006 at 09:21:39AM +0800, Zhang, Yanmin wrote:
> > On Thu, 2006-07-06 at 03:44, Linas Vepstas wrote:
> > > On Wed, Jul 05, 2006 at 08:49:27AM -0700, Auke Kok wrote:
> > > > Zhang, Yanmin wrote:
> > > > > On Fri, 2006-06-30 at 00:26, Linas Vepstas wrote:
> > > > > > Adds PCI Error recovery callbacks to the Intel 10-gigabit ethernet
> > > > > > ixgb device driver. Lightly tested, works.
> > > > > Both pci_disable_device and ixgb_down would access the device. It doesn't
> > > > > follow Documentation/pci-error-recovery.txt that error_detected shouldn't 
> > > > > do
> > > > > any access to the device.
> > > > Moreover, it was Linas who wrote this documentation in the first place :)
> > > On the pSeries, its harmless to try to do i/o; the i/o will e blocked.
> > In the future, we might move the pci error recovery codes to generic to
> > support other platforms which might not block I/O. So it's better to follow
> > Documentation/pci-error-recovery.txt when adding error recovery codes into driver.
>
> Or we could change the documentation. The point was that doing
> unexpected i/o after the aapter reset is likely to wedge the adapter
> again, leading to an inf loop of resets. As a practical matter, 
> I found that, while developing this patch, and the other related
> patches, that this was indeed the usual failure mode: incorrect bringup
> just lead to more errors.
>
> What I really want to do is to perform as clean a shut-down as possible, 
> reset the adapter, and then bring it back up.  I'm concerned that changing 
> the order to "reset"-"shutdown-"bringup" would be inappropriate.
>
> Perhaps the right fix is to figure out what parts of the driver do i/o
> during shutdown, and then add a line "if(wedged) skip i/o;" to those
> places?

that would be relatively simple if we can check a flag (?) somewhere that 
signifies that we've encountered a pci error. We basically only need to skip 
out after e1000_reset and bypass e1000_irq_disable in e1000_down() then.

Does the pci error recovery code give us such a flag?

Auke
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/