RE: [PATCH 1/7] CCISS: disable device when returning failure

["Miller, Mike (OS Dev)" <Mike.Miller@hp.com>]

> -----Original Message-----
> From: Helgaas, Bjorn 
> Sent: Wednesday, June 14, 2006 6:09 PM
> To: Miller, Mike (OS Dev)
> Cc: ISS StorageDev; linux-kernel@vger.kernel.org; Andrew Morton
> Subject: [PATCH 1/7] CCISS: disable device when returning failure
> 
> If something fails after we call pci_enable_device(), we should call
> pci_disable_device() before returning the failure.
> 
> Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>

Acked-by: Mike Miller <mike.miller@hp.com>

> 
> Index: rc5-mm3/drivers/block/cciss.c
> ===================================================================
> --- rc5-mm3.orig/drivers/block/cciss.c	2006-06-14 
> 14:29:40.000000000 -0600
> +++ rc5-mm3/drivers/block/cciss.c	2006-06-14 
> 14:36:03.000000000 -0600
> @@ -2744,7 +2744,7 @@
>  	__u64 cfg_offset;
>  	__u32 cfg_base_addr;
>  	__u64 cfg_base_addr_index;
> -	int i;
> +	int i, err;
>  
>  	/* check to see if controller has been disabled */
>  	/* BEFORE trying to enable it */
> @@ -2752,13 +2752,14 @@
>  	if(!(command & 0x02))
>  	{
>  		printk(KERN_WARNING "cciss: controller appears 
> to be disabled\n");
> -		return(-1);
> +		return -ENODEV;
>  	}
>  
> -	if (pci_enable_device(pdev))
> +	err = pci_enable_device(pdev);
> +	if (err)
>  	{
>  		printk(KERN_ERR "cciss: Unable to Enable PCI device\n");
> -		return( -1);
> +		return err;
>  	}
>  
>  	subsystem_vendor_id = pdev->subsystem_vendor; @@ 
> -2824,7 +2825,8 @@
>  	}
>  	if (scratchpad != CCISS_FIRMWARE_READY) {
>  		printk(KERN_WARNING "cciss: Board not ready.  
> Timed out.\n");
> -		return -1;
> +		err = -ENODEV;
> +		goto err_out_disable_pdev;
>  	}
>  
>  	/* get the address index number */
> @@ -2841,7 +2843,8 @@
>  	if (cfg_base_addr_index == -1) {
>  		printk(KERN_WARNING "cciss: Cannot find 
> cfg_base_addr_index\n");
>  		release_io_mem(c);
> -		return -1;
> +		err = -ENODEV;
> +		goto err_out_disable_pdev;
>  	}
>  
>  	cfg_offset = readl(c->vaddr + SA5_CTMEM_OFFSET); @@ 
> -2868,7 +2871,8 @@
>  		printk(KERN_WARNING "cciss: Sorry, I don't know how"
>  			" to access the Smart Array controller 
> %08lx\n", 
>  				(unsigned long)board_id);
> -		return -1;
> +		err = -ENODEV;
> +		goto err_out_disable_pdev;
>  	}
>  	if (  (readb(&c->cfgtable->Signature[0]) != 'C') ||
>  	      (readb(&c->cfgtable->Signature[1]) != 'I') || @@ 
> -2876,7 +2880,8 @@
>  	      (readb(&c->cfgtable->Signature[3]) != 'S') )
>  	{
>  		printk("Does not appear to be a valid CISS 
> config table\n");
> -		return -1;
> +		err = -ENODEV;
> +		goto err_out_disable_pdev;
>  	}
>  
>  #ifdef CONFIG_X86
> @@ -2920,10 +2925,14 @@
>  	{
>  		printk(KERN_WARNING "cciss: unable to get board into"
>  					" simple mode\n");
> -		return -1;
> +		err = -ENODEV;
> +		goto err_out_disable_pdev;
>  	}
>  	return 0;
>  
> +err_out_disable_pdev:
> +	pci_disable_device(pdev);
> +	return err;
>  }
>  
>  /* 
> 
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/