[PATCH 10/22] [PATCH] TG3: ethtool always report port is TP.

[Chris Wright <chrisw@sous-sol.org>]

-stable review patch.  If anyone has any objections, please let us know.
------------------

Even with fiber cards ethtool reports that the connected port is TP,
the patch fix this.

Signed-off-by: Karsten Keil <kkeil@suse.de>
Acked-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: "David S. Miller" <davem@davemloft.net>
Signed-off-by: Chris Wright <chrisw@sous-sol.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
---

 drivers/net/tg3.c |    8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

--- linux-2.6.16.16.orig/drivers/net/tg3.c
+++ linux-2.6.16.16/drivers/net/tg3.c
@@ -7368,21 +7368,23 @@ static int tg3_get_settings(struct net_d
 		cmd->supported |= (SUPPORTED_1000baseT_Half |
 				   SUPPORTED_1000baseT_Full);
 
-	if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES))
+	if (!(tp->tg3_flags2 & TG3_FLG2_ANY_SERDES)) {
 		cmd->supported |= (SUPPORTED_100baseT_Half |
 				  SUPPORTED_100baseT_Full |
 				  SUPPORTED_10baseT_Half |
 				  SUPPORTED_10baseT_Full |
 				  SUPPORTED_MII);
-	else
+		cmd->port = PORT_TP;
+	} else {
 		cmd->supported |= SUPPORTED_FIBRE;
+		cmd->port = PORT_FIBRE;
+	}
   
 	cmd->advertising = tp->link_config.advertising;
 	if (netif_running(dev)) {
 		cmd->speed = tp->link_config.active_speed;
 		cmd->duplex = tp->link_config.active_duplex;
 	}
-	cmd->port = 0;
 	cmd->phy_address = PHY_ADDR;
 	cmd->transceiver = 0;
 	cmd->autoneg = tp->link_config.autoneg;

--
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/