Aculab E1/T1 PMXc cPCI carrier card cards present a natsemi on the cPCI
bus wired up in a non-standard fashion. This patch provides support in
the natsemi driver for these cards by implementing a quirk mechanism and
using that to configure appropriate settings for the card: forcing 100M
full duplex, having a large EEPROM and using the MII port while ignoring
PHYs.
Signed-off-by: Mark Brown <[email protected]>
Index: natsemi-queue/drivers/net/natsemi.c
===================================================================
--- natsemi-queue.orig/drivers/net/natsemi.c 2006-02-25 17:41:59.000000000 +0000
+++ natsemi-queue/drivers/net/natsemi.c 2006-03-08 21:44:12.000000000 +0000
@@ -226,7 +226,6 @@ static int full_duplex[MAX_UNITS];
NATSEMI_PG1_NREGS)
#define NATSEMI_REGS_VER 1 /* v1 added RFDR registers */
#define NATSEMI_REGS_SIZE (NATSEMI_NREGS * sizeof(u32))
-#define NATSEMI_DEF_EEPROM_SIZE 24 /* 12 16-bit values */
/* Buffer sizes:
* The nic writes 32-bit values, even if the upper bytes of
@@ -344,12 +343,14 @@ None characterised.
-enum pcistuff {
+enum natsemi_quirks {
PCI_USES_IO = 0x01,
PCI_USES_MEM = 0x02,
PCI_USES_MASTER = 0x04,
PCI_ADDR0 = 0x08,
PCI_ADDR1 = 0x10,
+ MEDIA_FORCE_100FD = 0x20,
+ MEDIA_IGNORE_PHY = 0x40,
};
/* MMIO operations required */
@@ -367,17 +368,21 @@ enum pcistuff {
#define MII_FX_SEL 0x0001 /* 100BASE-FX (fiber) */
#define MII_EN_SCRM 0x0004 /* enable scrambler (tp) */
-
/* array of board data directly indexed by pci_tbl[x].driver_data */
static const struct {
const char *name;
unsigned long flags;
+ int quirks;
+ int eeprom_size;
} natsemi_pci_info[] __devinitdata = {
- { "NatSemi DP8381[56]", PCI_IOTYPE },
+ { "NatSemi DP8381[56]", PCI_IOTYPE, 0, 24 },
+ { "Aculab E1/T1 PMXc cPCI carrier card", PCI_IOTYPE,
+ MEDIA_FORCE_100FD | MEDIA_IGNORE_PHY, 128 },
};
static struct pci_device_id natsemi_pci_tbl[] = {
- { PCI_VENDOR_ID_NS, PCI_DEVICE_ID_NS_83815, PCI_ANY_ID, PCI_ANY_ID, },
+ { PCI_VENDOR_ID_NS, PCI_DEVICE_ID_NS_83815, PCI_VENDOR_ID_ACULAB, PCI_SUBDEVICE_ID_ACULAB_174, 0, 0, 1 },
+ { PCI_VENDOR_ID_NS, PCI_DEVICE_ID_NS_83815, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
{ 0, },
};
MODULE_DEVICE_TABLE(pci, natsemi_pci_tbl);
@@ -815,6 +820,39 @@ static void move_int_phy(struct net_devi
udelay(1);
}
+static void __devinit natsemi_init_media (struct net_device *dev)
+{
+ struct netdev_private *np = netdev_priv(dev);
+ u32 tmp;
+
+ tmp = mdio_read(dev, MII_BMCR);
+ np->speed = (tmp & BMCR_SPEED100)? SPEED_100 : SPEED_10;
+ np->duplex = (tmp & BMCR_FULLDPLX)? DUPLEX_FULL : DUPLEX_HALF;
+ np->autoneg = (tmp & BMCR_ANENABLE)? AUTONEG_ENABLE: AUTONEG_DISABLE;
+ np->advertising= mdio_read(dev, MII_ADVERTISE);
+
+ if ((np->advertising & ADVERTISE_ALL) != ADVERTISE_ALL
+ && netif_msg_probe(np)) {
+ printk(KERN_INFO "natsemi %s: Transceiver default autonegotiation %s "
+ "10%s %s duplex.\n",
+ pci_name(np->pci_dev),
+ (mdio_read(dev, MII_BMCR) & BMCR_ANENABLE)?
+ "enabled, advertise" : "disabled, force",
+ (np->advertising &
+ (ADVERTISE_100FULL|ADVERTISE_100HALF))?
+ "0" : "",
+ (np->advertising &
+ (ADVERTISE_100FULL|ADVERTISE_10FULL))?
+ "full" : "half");
+ }
+ if (netif_msg_probe(np))
+ printk(KERN_INFO
+ "natsemi %s: Transceiver status %#04x advertising %#04x.\n",
+ pci_name(np->pci_dev), mdio_read(dev, MII_BMSR),
+ np->advertising);
+
+}
+
static int __devinit natsemi_probe1 (struct pci_dev *pdev,
const struct pci_device_id *ent)
{
@@ -894,17 +932,21 @@ static int __devinit natsemi_probe1 (str
np->msg_enable = (debug >= 0) ? (1<<debug)-1 : NATSEMI_DEF_MSG;
np->hands_off = 0;
np->intr_status = 0;
- np->eeprom_size = NATSEMI_DEF_EEPROM_SIZE;
+ np->eeprom_size = natsemi_pci_info[chip_idx].eeprom_size;
option = find_cnt < MAX_UNITS ? options[find_cnt] : 0;
if (dev->mem_start)
option = dev->mem_start;
/* Ignore the PHY status? */
- if (option & 0x400) {
+ if (natsemi_pci_info[chip_idx].quirks & MEDIA_IGNORE_PHY) {
np->ignore_phy = 1;
} else {
- np->ignore_phy = 0;
+ if (option & 0x400) {
+ np->ignore_phy = 1;
+ } else {
+ np->ignore_phy = 0;
+ }
}
/* Initial port:
@@ -936,6 +978,12 @@ static int __devinit natsemi_probe1 (str
np->phy_addr_external = PHY_ADDR_INTERNAL;
}
+ /* Apply any speed quirks. */
+ if (natsemi_pci_info[chip_idx].quirks & MEDIA_FORCE_100FD) {
+ np->speed = 100;
+ np->duplex = 1;
+ }
+
/* The lower four bits are the media type. */
if (option) {
if (option & 0x200)
@@ -974,32 +1022,10 @@ static int __devinit natsemi_probe1 (str
else
netif_carrier_off(dev);
- /* get the initial settings from hardware */
- tmp = mdio_read(dev, MII_BMCR);
- np->speed = (tmp & BMCR_SPEED100)? SPEED_100 : SPEED_10;
- np->duplex = (tmp & BMCR_FULLDPLX)? DUPLEX_FULL : DUPLEX_HALF;
- np->autoneg = (tmp & BMCR_ANENABLE)? AUTONEG_ENABLE: AUTONEG_DISABLE;
- np->advertising= mdio_read(dev, MII_ADVERTISE);
-
- if ((np->advertising & ADVERTISE_ALL) != ADVERTISE_ALL
- && netif_msg_probe(np)) {
- printk(KERN_INFO "natsemi %s: Transceiver default autonegotiation %s "
- "10%s %s duplex.\n",
- pci_name(np->pci_dev),
- (mdio_read(dev, MII_BMCR) & BMCR_ANENABLE)?
- "enabled, advertise" : "disabled, force",
- (np->advertising &
- (ADVERTISE_100FULL|ADVERTISE_100HALF))?
- "0" : "",
- (np->advertising &
- (ADVERTISE_100FULL|ADVERTISE_10FULL))?
- "full" : "half");
- }
- if (netif_msg_probe(np))
- printk(KERN_INFO
- "natsemi %s: Transceiver status %#04x advertising %#04x.\n",
- pci_name(np->pci_dev), mdio_read(dev, MII_BMSR),
- np->advertising);
+ /* get the initial settings from hardware if we don't have any
+ * already */
+ if (!np->speed)
+ natsemi_init_media(dev);
/* save the silicon revision for later querying */
np->srr = readl(ioaddr + SiliconRev);
Index: natsemi-queue/include/linux/pci_ids.h
===================================================================
--- natsemi-queue.orig/include/linux/pci_ids.h 2006-02-25 19:19:55.000000000 +0000
+++ natsemi-queue/include/linux/pci_ids.h 2006-02-25 19:21:28.000000000 +0000
@@ -1573,6 +1573,7 @@
#define PCI_DEVICE_ID_NVIDIA_SGS_RIVA128 0x0018
#define PCI_VENDOR_ID_ACULAB 0x12d9
+#define PCI_SUBDEVICE_ID_ACULAB_174 0x000c
#define PCI_SUBVENDOR_ID_CHASE_PCIFAST 0x12E0
#define PCI_SUBDEVICE_ID_CHASE_PCIFAST4 0x0031
--
"You grabbed my hand and we fell into it, like a daydream - or a fever."
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
