patch "e100: Fix TX hang and RMCP Ping issue" (post-2.6.16-rc1) causes suspend-to-ram breakage

[Dominik Brodowski <linux@dominikbrodowski.net>]

Hi,

git bisect revealed that 24180333206519e6b0c4633eab81e773b4527cac is 
the first bad commit, which is 

"e100: Fix TX hang and RMCP Ping issue (due to a microcode loading issue)"

With it applied, suspend-to-ram fails to resume to userspace, which is
required on my system to get video back (vbetool). 

02:08.0 Ethernet controller: Intel Corporation 82801DB PRO/100 VE (MOB) Ethernet Controller (rev 81)
	Subsystem: Samsung Electronics Co Ltd Unknown device c009
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR+ FastB2B-
	Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 66 (2000ns min, 14000ns max), Cache Line Size 08
	Interrupt: pin A routed to IRQ 5
	Region 0: Memory at e0201000 (32-bit, non-prefetchable) [size=4K]
	Region 1: I/O ports at 3000 [size=64]
	Capabilities: [dc] Power Management version 2
		Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
		Status: D0 PME-Enable- DSel=0 DScale=2 PME-

eth0      Link encap:Ethernet  HWaddr ...................
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

Settings for eth0:
	Supported ports: [ TP MII ]
	Supported link modes:   10baseT/Half 10baseT/Full 
	                        100baseT/Half 100baseT/Full 
	Supports auto-negotiation: Yes
	Advertised link modes:  10baseT/Half 10baseT/Full 
	                        100baseT/Half 100baseT/Full 
	Advertised auto-negotiation: Yes
	Speed: 10Mb/s
	Duplex: Half
	Port: MII
	PHYAD: 1
	Transceiver: internal
	Auto-negotiation: on
	Supports Wake-on: g
	Wake-on: g
	Current message level: 0x00000007 (7)
	Link detected: no


No cable inserted, therefore the link is down...

	Dominik
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/