change eth0 to sn0 ?

["Ratheesh k" <ratheesh.ksz@hotmail.com>]

i m using  fc3


$ ifconfig

eth0      Link encap:Ethernet  HWaddr 00:11:2F:38:07:D9
          inet addr:172.16.7.104  Bcast:172.16.7.255  Mask:255.255.252.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:6506 errors:0 dropped:0 overruns:0 frame:0
         TX packets:5120 errors:0 dropped:0 overruns:0 carrier:0
         collisions:1256 txqueuelen:1000
         RX bytes:1951142 (1.8 Mb)  TX bytes:1027381 (1003.3 Kb)
         Interrupt:23 Base address:0x3800

lo        Link encap:Local Loopback
         inet addr:127.0.0.1  Mask:255.0.0.0
         UP LOOPBACK RUNNING  MTU:16436  Metric:1
         RX packets:78 errors:0 dropped:0 overruns:0 frame:0
         TX packets:78 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:0
         RX bytes:5420 (5.2 Kb)  TX bytes:5420 (5.2 Kb)


    $ ifconfig eth0 down
    $ ifconfig sn0  172.16.8.1   netmask 255.255.252.0

sn0  intreface is added by driver .


what i want is , i want to  use the hw addreess of eth0 , irq of eth0 to sn0 
.

ie , i want  to do

$ ifconfig  sno 172.16.8.1 mtu 1500 irq 193 hw ether 00:11:2f:77:fd:c2

what i have to do ?

_________________________________________________________________
How good are you in a Formula One car? Play now 
http://server1.msn.co.in/sp05/tataracing/onlinegame.asp

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/