Signed-off-by: Adrian Bunk <[email protected]>
---
Documentation/cachetlb.txt | 2 +-
Documentation/ioctl/hdio.txt | 2 +-
Documentation/laptop-mode.txt | 2 +-
Documentation/networking/sk98lin.txt | 2 +-
Documentation/x86_64/boot-options.txt | 2 +-
drivers/s390/scsi/zfcp_erp.c | 2 +-
drivers/scsi/gdth.c | 2 +-
sound/oss/opl3sa2.c | 2 +-
8 files changed, 8 insertions(+), 8 deletions(-)
--- linux-2.6.15-mm3-full/Documentation/cachetlb.txt.old 2006-01-14 02:19:46.000000000 +0100
+++ linux-2.6.15-mm3-full/Documentation/cachetlb.txt 2006-01-14 02:20:02.000000000 +0100
@@ -136,7 +136,7 @@
8) void lazy_mmu_prot_update(pte_t pte)
This interface is called whenever the protection on
any user PTEs change. This interface provides a notification
- to architecture specific code to take appropiate action.
+ to architecture specific code to take appropriate action.
Next, we have the cache flushing interfaces. In general, when Linux
--- linux-2.6.15-mm3-full/Documentation/ioctl/hdio.txt.old 2006-01-14 02:20:09.000000000 +0100
+++ linux-2.6.15-mm3-full/Documentation/ioctl/hdio.txt 2006-01-14 02:20:14.000000000 +0100
@@ -946,7 +946,7 @@
This ioctl initializes the addresses and irq for a disk
controller, probes for drives, and creates /proc/ide
- interfaces as appropiate.
+ interfaces as appropriate.
--- linux-2.6.15-mm3-full/Documentation/laptop-mode.txt.old 2006-01-14 02:20:25.000000000 +0100
+++ linux-2.6.15-mm3-full/Documentation/laptop-mode.txt 2006-01-14 02:20:30.000000000 +0100
@@ -357,7 +357,7 @@
# Read-ahead, in kilobytes
READAHEAD=${READAHEAD:-'4096'}
-# Shall we remount journaled fs. with appropiate commit interval? (1=yes)
+# Shall we remount journaled fs. with appropriate commit interval? (1=yes)
DO_REMOUNTS=${DO_REMOUNTS:-'1'}
# And shall we add the "noatime" option to that as well? (1=yes)
--- linux-2.6.15-mm3-full/Documentation/networking/sk98lin.txt.old 2006-01-14 02:20:37.000000000 +0100
+++ linux-2.6.15-mm3-full/Documentation/networking/sk98lin.txt 2006-01-14 02:20:44.000000000 +0100
@@ -91,7 +91,7 @@
with (M)
5. Execute the command "make modules".
6. Execute the command "make modules_install".
- The appropiate modules will be installed.
+ The appropriate modules will be installed.
7. Reboot your system.
--- linux-2.6.15-mm3-full/Documentation/x86_64/boot-options.txt.old 2006-01-14 02:20:52.000000000 +0100
+++ linux-2.6.15-mm3-full/Documentation/x86_64/boot-options.txt 2006-01-14 02:20:57.000000000 +0100
@@ -198,6 +198,6 @@
Misc
- noreplacement Don't replace instructions with more appropiate ones
+ noreplacement Don't replace instructions with more appropriate ones
for the CPU. This may be useful on asymmetric MP systems
where some CPU have less capabilities than the others.
--- linux-2.6.15-mm3-full/drivers/s390/scsi/zfcp_erp.c.old 2006-01-14 02:21:04.000000000 +0100
+++ linux-2.6.15-mm3-full/drivers/s390/scsi/zfcp_erp.c 2006-01-14 02:21:08.000000000 +0100
@@ -3403,7 +3403,7 @@
/**
* zfcp_erp_action_cleanup
*
- * Register unit with scsi stack if appropiate and fix reference counts.
+ * Register unit with scsi stack if appropriate and fix reference counts.
* Note: Temporary units are not registered with scsi stack.
*/
static void
--- linux-2.6.15-mm3-full/drivers/scsi/gdth.c.old 2006-01-14 02:21:15.000000000 +0100
+++ linux-2.6.15-mm3-full/drivers/scsi/gdth.c 2006-01-14 02:21:20.000000000 +0100
@@ -328,7 +328,7 @@
* hdr_channel:x x - number of virtual bus for host drives
* shared_access:Y disable driver reserve/release protocol to
* access a shared resource from several nodes,
- * appropiate controller firmware required
+ * appropriate controller firmware required
* shared_access:N enable driver reserve/release protocol
* probe_eisa_isa:Y scan for EISA/ISA controllers
* probe_eisa_isa:N do not scan for EISA/ISA controllers
--- linux-2.6.15-mm3-full/sound/oss/opl3sa2.c.old 2006-01-14 02:21:27.000000000 +0100
+++ linux-2.6.15-mm3-full/sound/oss/opl3sa2.c 2006-01-14 02:21:34.000000000 +0100
@@ -530,7 +530,7 @@
if (hw_config->slots[0] != -1) {
/* Did the MSS driver install? */
if(num_mixers == (initial_mixers + 1)) {
- /* The MSS mixer is installed, reroute mixers appropiately */
+ /* The MSS mixer is installed, reroute mixers appropriately */
AD1848_REROUTE(SOUND_MIXER_LINE1, SOUND_MIXER_CD);
AD1848_REROUTE(SOUND_MIXER_LINE2, SOUND_MIXER_SYNTH);
AD1848_REROUTE(SOUND_MIXER_LINE3, SOUND_MIXER_LINE);
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
