Re: [PATCH] Disable swsusp on CONFIG_HIGHMEM64

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Dne pátek 06 leden 2006 05:30 Pavel Machek napsal(a):
> On Sat 07-01-06 16:04:03, Jan Spitalnik wrote:
> > Dne pátek 06 leden 2006 00:43 Pavel Machek napsal(a):
> > > On Fri 06-01-06 19:45:09, Jan Spitalnik wrote:
> > > > Hello,
> > > >
> > > > suspending to disk is not supported on CONFIG_HIGHMEM64G setups
> > > > (http://suspend2.net/features). Also suspend to ram doesn't work.
> > > > This patch
> > >
> > > NAK. suspend2.net describes very different code.
> >
> > Well, I was using suspend2.net's page just as reference, to point out the
> > fact that HIGHMEM is on both suspend "platforms" supported only up to 4G.
> > I was not refering to suspend2's actual features, but rather swsusp's (or
> > what's the proper name for suspend1 code). So i guess the patch still
> > holds, no?
>
> No.

Could you be please more specific? Is there some list of swsusp's features? 
swsusp.txt says that it "A: It should work okay with highmem." Does that mean 
both possible highmem configurations?

>
> > > > fixes Kconfig to disallow such combination. I'm not 100% sure about
> > > > the ACPI_SLEEP part, as it might be disabling some working setup -
> > > > but i think that s2r and s2d are the only acpi sleeps allowed, no?
> > >
> > > s2ram probably works. Try getting it working without highmem64,
> > > then turn it on.
> >
> > It works with HIGHMEM but not HIGHMEM64G. You can find the oops from
> > HIGHMEM64G below. It crashes very reliably on little stress after resume.
>
> s2ram should not depend on ammount of memory. Try debugging
> it, but do not disable feature just because it does not work
> for you. I'd start with minimum drivers...

Well, I've tried it with the bare minimum that was needed to run the system, 
but it did the same. I'm sorry but i lack the knowledge to properly debug it 
on source level.  Do you see something that perhaps i don't see in the oops? 
Maybe some clues as what might be going wrong?

Thanks,

-- 
Jan Spitalnik
[email protected]
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux