From: Andi Kleen <[email protected]>
They report all busses as MMCONFIG capable, but it never works for the
internal devices in the CPU's builtin northbridge.
This causes problems - some devices are not visible and on x86-64 the
IOMMU is not detected, causing boot failures on systems with >3GB of
RAM. It also breaks AGP.
Workaround just probes all func 0 devices on bus 0 (the internal
northbridge is currently always on bus 0) and if they are not accessible
using MCFG they are put into a special fallback bitmap.
On systems where it isn't we assume the BIOS vendor supplied correct
MCFG.
Requires the earlier patch for mmconfig type1 fallback
Signed-off-by: Andi Kleen <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>
---
arch/i386/pci/mmconfig.c | 45 ++++++++++++++++++++++++++++++++++++++++++---
arch/x86_64/pci/mmconfig.c | 36 ++++++++++++++++++++++++++++++++++--
2 files changed, 76 insertions(+), 5 deletions(-)
--- greg-2.6.orig/arch/x86_64/pci/mmconfig.c
+++ greg-2.6/arch/x86_64/pci/mmconfig.c
@@ -8,10 +8,13 @@
#include <linux/pci.h>
#include <linux/init.h>
#include <linux/acpi.h>
+#include <linux/bitmap.h>
#include "pci.h"
#define MMCONFIG_APER_SIZE (256*1024*1024)
+static DECLARE_BITMAP(fallback_slots, 32);
+
/* Static virtual mapping of the MMCONFIG aperture */
struct mmcfg_virt {
struct acpi_table_mcfg_config *cfg;
@@ -40,9 +43,12 @@ static char *get_virt(unsigned int seg,
}
}
-static inline char *pci_dev_base(unsigned int seg, unsigned int bus, unsigned int devfn)
+static char *pci_dev_base(unsigned int seg, unsigned int bus, unsigned int devfn)
{
- char *addr = get_virt(seg, bus);
+ char *addr;
+ if (seg == 0 && bus == 0 && test_bit(PCI_SLOT(devfn), &fallback_slots))
+ return NULL;
+ addr = get_virt(seg, bus);
if (!addr)
return NULL;
return addr + ((bus << 20) | (devfn << 12));
@@ -109,6 +115,30 @@ static struct pci_raw_ops pci_mmcfg = {
.write = pci_mmcfg_write,
};
+/* K8 systems have some devices (typically in the builtin northbridge)
+ that are only accessible using type1
+ Normally this can be expressed in the MCFG by not listing them
+ and assigning suitable _SEGs, but this isn't implemented in some BIOS.
+ Instead try to discover all devices on bus 0 that are unreachable using MM
+ and fallback for them.
+ We only do this for bus 0/seg 0 */
+static __init void unreachable_devices(void)
+{
+ int i;
+ for (i = 0; i < 32; i++) {
+ u32 val1;
+ char *addr;
+
+ pci_conf1_read(0, 0, PCI_DEVFN(i,0), 0, 4, &val1);
+ if (val1 == 0xffffffff)
+ continue;
+ addr = pci_dev_base(0, 0, PCI_DEVFN(i, 0));
+ if (addr == NULL || readl(addr) != val1) {
+ set_bit(i, &fallback_slots);
+ }
+ }
+}
+
static int __init pci_mmcfg_init(void)
{
int i;
@@ -139,6 +169,8 @@ static int __init pci_mmcfg_init(void)
printk(KERN_INFO "PCI: Using MMCONFIG at %x\n", pci_mmcfg_config[i].base_address);
}
+ unreachable_devices();
+
raw_pci_ops = &pci_mmcfg;
pci_probe = (pci_probe & ~PCI_PROBE_MASK) | PCI_PROBE_MMCONF;
--- greg-2.6.orig/arch/i386/pci/mmconfig.c
+++ greg-2.6/arch/i386/pci/mmconfig.c
@@ -19,14 +19,20 @@
/* The base address of the last MMCONFIG device accessed */
static u32 mmcfg_last_accessed_device;
+static DECLARE_BITMAP(fallback_slots, 32);
+
/*
* Functions for accessing PCI configuration space with MMCONFIG accesses
*/
-static u32 get_base_addr(unsigned int seg, int bus)
+static u32 get_base_addr(unsigned int seg, int bus, unsigned devfn)
{
int cfg_num = -1;
struct acpi_table_mcfg_config *cfg;
+ if (seg == 0 && bus == 0 &&
+ test_bit(PCI_SLOT(devfn), fallback_slots))
+ return 0;
+
while (1) {
++cfg_num;
if (cfg_num >= pci_mmcfg_config_num) {
@@ -60,7 +66,7 @@ static int pci_mmcfg_read(unsigned int s
if (!value || (bus > 255) || (devfn > 255) || (reg > 4095))
return -EINVAL;
- base = get_base_addr(seg, bus);
+ base = get_base_addr(seg, bus, devfn);
if (!base)
return pci_conf1_read(seg,bus,devfn,reg,len,value);
@@ -94,7 +100,7 @@ static int pci_mmcfg_write(unsigned int
if ((bus > 255) || (devfn > 255) || (reg > 4095))
return -EINVAL;
- base = get_base_addr(seg, bus);
+ base = get_base_addr(seg, bus, devfn);
if (!base)
return pci_conf1_write(seg,bus,devfn,reg,len,value);
@@ -124,6 +130,37 @@ static struct pci_raw_ops pci_mmcfg = {
.write = pci_mmcfg_write,
};
+/* K8 systems have some devices (typically in the builtin northbridge)
+ that are only accessible using type1
+ Normally this can be expressed in the MCFG by not listing them
+ and assigning suitable _SEGs, but this isn't implemented in some BIOS.
+ Instead try to discover all devices on bus 0 that are unreachable using MM
+ and fallback for them.
+ We only do this for bus 0/seg 0 */
+static __init void unreachable_devices(void)
+{
+ int i;
+ unsigned long flags;
+
+ for (i = 0; i < 32; i++) {
+ u32 val1;
+ u32 addr;
+
+ pci_conf1_read(0, 0, PCI_DEVFN(i, 0), 0, 4, &val1);
+ if (val1 == 0xffffffff)
+ continue;
+
+ /* Locking probably not needed, but safer */
+ spin_lock_irqsave(&pci_config_lock, flags);
+ addr = get_base_addr(0, 0, PCI_DEVFN(i, 0));
+ if (addr != 0)
+ pci_exp_set_dev_base(addr, 0, PCI_DEVFN(i, 0));
+ if (addr == 0 || readl((u32 *)addr) != val1)
+ set_bit(i, fallback_slots);
+ spin_unlock_irqrestore(&pci_config_lock, flags);
+ }
+}
+
static int __init pci_mmcfg_init(void)
{
if ((pci_probe & PCI_PROBE_MMCONF) == 0)
@@ -139,6 +176,8 @@ static int __init pci_mmcfg_init(void)
raw_pci_ops = &pci_mmcfg;
pci_probe = (pci_probe & ~PCI_PROBE_MASK) | PCI_PROBE_MMCONF;
+ unreachable_devices();
+
out:
return 0;
}
--
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
