Re: Poor Software RAID-0 performance with 2.6.14.2

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Nov 21, 2005 at 09:31:14PM +0100, Lars Roland wrote:
> I have created a stripe across two 500Gb disks located on separate IDE
> channels using:
> 
> mdadm -Cv /dev/md0 -c32 -n2 -l0 /dev/hdb /dev/hdd
> 
> the performance is awful on both kernel 2.6.12.5 and 2.6.14.2 (even
> with hdparm and blockdev tuning), both bonnie++ and hdparm (included
> below) shows a single disk operating faster than the stripe:
> 
To rule out hardware problems (harware not as parallel as you might think):

Try running the performance test (bonnie++ or hdparm)
on both /dev/hdb and /dev/hdd at the same time. 

Two hdparms on different disks should not take longer time than one,
unless you have bad hardware.

One bonnie with size x MB takes y minutes to run.
Two bonnies, each of size x/2 MB should take between
y/2 an y minutes to run. If they need more, then something
is wrong again, explaining bad RAID performance.

Helge Hafting


-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux