On Sat, Nov 19, 2005 at 07:23:43PM +0000, [email protected] wrote:
>
> -------------- Original message ----------------------
> From: Vojtech Pavlik <[email protected]>
> > On Sat, Nov 19, 2005 at 06:59:37PM +0000, [email protected] wrote:
> > > My HP ze1115 notebook uses the via82cxxx ide driver. If I configure the kernel
> > build to make that driver as a module, the driver is correctly added to initrd
> > and is loaded at boot time; however, DMA mode is turned off. It cannot be turned
> > on even if I use an 'hdparm -d1 /dev/hda' command.
> > >
> > > Is this a bug, or do I need some kind of IDE=XXX boot command? As expected,
> > system performance in this mode is horrible.
> >
> > What chipset does your notebook use? 'lspci -vv' should give a good
> > answer.
>
> Portion of output of lspci -vv:
>
> 00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
> Subsystem: Hewlett-Packard Company: Unknown device 0022
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> Latency: 64
> Region 4: I/O ports at 1100 [size=16]
> Capabilities: [c0] Power Management version 2
> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
I need the portion for the ISA bridge, surprisingly, to know.
--
Vojtech Pavlik
SuSE Labs, SuSE CR
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
