How do I tell Linux kernel 2.4.25 on boot-time kernel commandline to
switch my eth0
-----------------------------------------------------------------------
Bus 1, device 3, function 0:
Ethernet controller: 3Com Corporation 3c900 Combo [Boomerang] (rev
0).
IRQ 11.
Master Capable. Latency=32. Min Gnt=3.Max Lat=8.
I/O at 0xc000 [0xc03f].
-----------------------------------------------------------------------
to TP transceiver and 10/100 autonegotiation?
I looked into Documentation/00-INDEX and into kernel-parameters.txt and
found just
" ether= [HW,NET] Ethernet cards parameters (irq,
base_io_addr, mem_start, mem_end, name.
(mem_start is often overloaded to mean something
different and driver-specific).
"
which neither doesn't answer my question neither point to any
documentation where my question could be answered.
CL<
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
