Hi,
I will check code in several days, but I cannot re-produce a problem in a moment
because I am away from home for business trip.
In my understand, the driver recognize the CPU properly.
At Fri, 26 Aug 2005 19:01:37 +0100,
Jose Miguel Goncalves wrote:
>
> Hi all,
>
> I'm trying to use cpufreq on my Geode GX1 board with linux-2.6.12.5, but,
> while everything seems OK, i.e., I can change from performance to powersave
> governor and back and /proc/cpuinfo reports me frequency changes, I can
> get no effective frequency/CPU power change because I check it with
> the Whetstone benchmark and it allways give me the same value (~100 MWIPS).
> Any ideas from were could be the problem?
Can you try to check also follows?
/sys/devices/system/cpu/cpu0/cpufreq/scaling_cur_freq
/sys/devices/system/cpu/cpu0/cpufreq/cpuinfo_cur_freq
With this driver, it will significantly slow down by setting powersave mode.
It seems some bus in the driver.
Thank you for report.
Hiroshi
--
Hiroshi Miura --- [email protected], Mobile --- [email protected]
NTTDATA Corp. OpenSource Software Center. --- [email protected]
NTTDATA Intellilink Corp. OpenSource Engineering Dev. -- [email protected]
Kobe Institute of Computing Graduate School of IT - Lecturer -- [email protected]
Key id=04AB8617 fingerprint=9117 9407 5684 FBF1 4063 15B4 401D D077 04AB 8617
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
| |
 |