Re: 2.6.13-rc3 Battery times at 100/250/1000 Hz = Zero difference

[Voluspa <voluspa@telia.com>]

On Fri, 22 Jul 2005 16:48:55 +0200 Pavel Machek wrote:
[...]
.......Jesper Juhl wrote
> > Ok, so with an idle machine, different HZ makes no noticeable
> > difference, but I'd suspect things would be different if the machine
> > was actually doing some work.
> > Would be more interresting to see how long it lasts with a light
> > load and with a heavy load.
> 
> No, I do not think so. Biggest difference should be on completely idle
> machine where ACPI can utilize low power states.
> 
> Can you check that C3 is utilized? Unloading usb modules may be
> neccessary...

I've been reading/checking up on this the last four hours since I
had a nagging suspicion that the CPU indeed didn't enter a sleep
state. With all the abbreviations in the ACPI field (S1, C1, P1 etc)
it killed a fair amount of brain cells, but I'd still call faul on this:

from /var/log/kernel
[powernow-k8 module loads processor module which says]
ACPI: CPU0 (power states: C1[C1])

and catting /proc/acpi/processor/CPU0/power gives
active state: C1
max_cstate: C8
bus master activity: 00000000
states:
   *C1: type[C1] promotion[--] demotion[--] latency[000] usage[02998796]

/sys/module/processor/parameters/max_cstate says 8
/sys/module/processor/parameters/bm_history says 4294967295

So I'm a bit baffled that no C2/C3 turns up. I've done a test-compile
with all of ACPI in kernel instead of as modules, but there was no
difference.

I'll unload the whole USB-module part and boot without loading them, but
will it matter? Please provide more details about how to debug this
(very confusing) field.

Mvh
Mats Johannesson
--
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/