2.6.12 can not support via rhine?

[guorke <gourke@gmail.com>]

hi
when i reboot use 2.6.11,it's ok.
but when i use 2.6.12 kernel, i get this:

via rhine device dose not seem to be present , delaying eth0 initialzation..
but in 2.6.11, it's say ok, I must say i have add via rhine support.
this following is difference output demsg :
diff -y dmesg_2.6.11 dmesg_2.6.12

VFS: Mounted root (ext3 filesystem) readonly.                   VFS:
Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 220k freed                      |
Freeing unused kernel memory: 224k freed
kjournald starting.  Commit interval 5 seconds                <
EXT3 FS on hda1, internal journal                               EXT3
FS on hda1, internal journal
Adding 265064k swap on /dev/hda2.  Priority:-1 extents:1        Adding
265064k swap on /dev/hda2.  Priority:-1 extents:1
via-rhine.c:v1.10-LK1.2.0-2.6 June-10-2004 Written by Donald  <
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 12             <
PCI: setting IRQ 12 as level-triggered                        <
ACPI: PCI interrupt 0000:00:09.0[A] -> GSI 12 (level, low) -> <
eth0: VIA Rhine II at 0x1e800, 00:05:5d:fb:7d:29, IRQ 12.     <
eth0: MII PHY found at address 8, status 0x782d advertising 0 <
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1               <

like no via rhine.

Thanks
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/