Bug in 8520.c - port.type not set for serial console

[Jim Ramsay <jim.ramsay@gmail.com>]

I am attempting to get the 8520.c driver's serial console working with
a 16550A UART implementation, and have run into what I consider to be
a bug:  In short, the proper 'port.type' for this serial port is not
set until the module init (serial8250_init) is called, so the FCR is
set incorrectly during serial8250_console_init for any port type which
is different than UNKNOWN.

The exact problem is that the FCR is being set to '0x0' for a port
type of 'UNKNOWN', when for my specific 16550A, it should be set to
'0xC1' - and this makes my screen fill with empty characters instead
of the printk output I need.  It appears that after some time (once
the kernel actually calls serial8250_init) the problem clears up, but
I still lose a large section of the output before this point.

The proper flags are sitting there in the uart_config array for the
proper type, and this type is properly deduced by the 'autoconfig'
routine that eventually gets called by serial8250_init.  The problem
is that the autoconfig is isn't called by serial8250_console_init
which of course happens much earlier than serial8250_init.

I have a workaround that works for me, telling the
serial8250_set_termios() routine to only set the FCR if the type is
not UNKNOWN, changing
    if (up->port.type != PORT_16750 ) {
to
    if (up->port.type != PORT_16750 && up->port.type != PORT_UNKNOWN) {

This will leave the FCR at whatever it was at boot time, which for me
is correct.

Would this be a "good enough" fix in general, or would there be a
better way of doing this?

I suppose the other way would be to duplicate some of what
serial8250_init does (like call 'autoconfig') in
serial8250_console_init, but I haven't tried this yet... maybe it
depends on too much kernel magic to be called as early as
'console_init'?

Any suggestions on the best way to fix this would be great, I'd be
happy to develop this more, test a bit, and submit a patch.

-- 
Jim Ramsay
"Me fail English?  That's unpossible!"
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/