cpufreq/speedstep won't work on Sony Vaio PCG-F807K

Hi,

subject says it all. The cpufreq interface won't show up (using kernel
2.6.12-rc4). I tried the speedstep-smi and acpi-cpufreq module. When I try to
insert one of them, modprobe just report: No such device.

At least the acpi on eshould work, as the bios allows to change freq via ACPI.
I laos fixed the dsdt and tried to use this one, but no difference.

An ideas?

Cheers,

Prakash


0000:00:00.0 Host bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX Host
bridge (rev 03)
        Subsystem: Sony Corporation: Unknown device 806f
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort+ >SERR- <PERR-
        Latency: 64
        Region 0: Memory at 40000000 (32-bit, prefetchable)
        Capabilities: [a0] AGP version 1.0
                Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans-
64bit- FW- AGP3- Rate=x1,x2
                Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW-
Rate=<none>

0000:00:01.0 PCI bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX AGP
bridge (rev 03) (prog-if 00 [Normal decode])
        Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV+ VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 128
        Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
        I/O behind bridge: 0000e000-0000efff
        Memory behind bridge: fd000000-fecfffff
        Prefetchable memory behind bridge: fff00000-000fffff
        Expansion ROM at 0000e000 [disabled] [size=4K]
        BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B+

0000:00:07.0 ISA bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 02)
        Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0

0000:00:07.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
(prog-if 80 [Master])
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 64
        Region 4: I/O ports at fc90 [size=16]

0000:00:07.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev
01) (prog-if 00 [UHCI])
        Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin D routed to IRQ 9
        Region 4: I/O ports at fca0 [size=32]

0000:00:07.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 03)
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin ? routed to IRQ 9

0000:00:08.0 FireWire (IEEE 1394): Sony Corporation CXD3222 i.LINK Controller
(rev 02) (prog-if 10 [OHCI])
        Subsystem: Sony Corporation: Unknown device 8071
        Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at fedf7000 (32-bit, non-prefetchable)
        Region 1: Memory at fedf7c00 (32-bit, non-prefetchable) [size=512]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

0000:00:09.0 Multimedia audio controller: Yamaha Corporation YMF-744B [DS-1S
Audio Controller] (rev 02)
        Subsystem: Sony Corporation: Unknown device 8072
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
        Latency: 64 (1250ns min, 6250ns max)
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at fedf8000 (32-bit, non-prefetchable)
        Region 1: I/O ports at fcc0 [size=64]
        Region 2: I/O ports at fc8c [size=4]
        Capabilities: [50] Power Management version 1
                Flags: PMEClk- DSI- D1- D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

0000:00:0a.0 Communication controller: Conexant HSF 56k Data/Fax Modem (Mob
WorldW SmartDAA) (rev 01)
        Subsystem: Sony Corporation Modem
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at fede0000 (32-bit, non-prefetchable)
        Region 1: I/O ports at fc78 [size=8]
        Capabilities: [40] Power Management version 2
                Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

0000:00:0c.0 CardBus bridge: Ricoh Co Ltd RL5c478 (rev 80)
        Subsystem: Sony Corporation: Unknown device 8073
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 168
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at 10000000 (32-bit, non-prefetchable)
        Bus: primary=00, secondary=02, subordinate=05, sec-latency=176
        Memory window 0: 10400000-107ff000 (prefetchable)
        Memory window 1: 10800000-10bff000
        I/O window 0: 00004000-000040ff
        I/O window 1: 00004400-000044ff
        BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt+ PostWrite+
        16-bit legacy interface ports at 0001

0000:00:0c.1 CardBus bridge: Ricoh Co Ltd RL5c478 (rev 80)
        Subsystem: Sony Corporation: Unknown device 8073
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 168
        Interrupt: pin B routed to IRQ 9
        Region 0: Memory at 10001000 (32-bit, non-prefetchable)
        Bus: primary=00, secondary=06, subordinate=09, sec-latency=176
        Memory window 0: 10c00000-10fff000 (prefetchable)
        Memory window 1: 11000000-113ff000
        I/O window 0: 00004800-000048ff
        I/O window 1: 00004c00-00004cff
        BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt+ PostWrite+
        16-bit legacy interface ports at 0001

0000:01:00.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M
AGP 2x (rev 64) (prog-if 00 [VGA])
        Subsystem: Sony Corporation: Unknown device 80ae
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping+ SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 66 (2000ns min), cache line size 08
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at fd000000 (32-bit, non-prefetchable)
        Region 1: I/O ports at e800 [size=256]
        Region 2: Memory at fecff000 (32-bit, non-prefetchable) [size=4K]
        Capabilities: [50] AGP version 1.0
                Status: RQ=256 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans-
64bit- FW- AGP3- Rate=x1,x2
                Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW-
Rate=<none>
        Capabilities: [5c] Power Management version 1
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Attachment: signature.asc
Description: OpenPGP digital signature
Follow-Ups:
- Re: cpufreq/speedstep won't work on Sony Vaio PCG-F807K
  - From: Dominik Brodowski <[email protected]>
Prev by Date: Re: [VFS-RFC] autofs4 and bind, rbind and move mount requests
Next by Date: [PATCH][2.6.12-rc4][SATA] sil driver - Blacklist Maxtor disk
Previous by thread: swsusp and kernel 2.6.12-rc4 does not work
Next by thread: Re: cpufreq/speedstep won't work on Sony Vaio PCG-F807K
Index(es):
- Date
- Thread
[Index of Archives] [Kernel Newbies] [Netfilter] [Bugtraq] [Photo] [Stuff] [Gimp] [Yosemite News] [MIPS Linux] [ARM Linux] [Linux Security] [Linux RAID] [Video 4 Linux] [Linux for the blind] [Linux Resources]