Re: [RESEND] Hard disk LBA sector count is not always the same

[Jeff Garzik <jgarzik@pobox.com>]

DervishD wrote:
>     Hi all :)
>
>     I'm resending this because although it doesn't seem to imply a
> hard disk failure, I have to repartition this disk and I must do it
> using a 2.6 kernel (long story), and I'm afraid that afterwards I
> cannot access the last sectors using 2.4 (since sometimes the disk is
> detected as being 2103 sectors smaller. I would appreciate any help,
> or if someone could point me to a source of information or a more
> appropriate mailing list.
>
>     I'm having a problem with my primary hard disk: it inconsistently
> reports the number of addressable LBA sectors. At times it reports
> 156301488 (let's call it '301' from now on) which is the correct one
> (I think) and other times it reports 156299375 (I'll call this one
> 299 from now on), a difference of 2103 sectors. But this is not
> arbitrary, I have reproduced the problem. I've done it using a
> self-compiled 2.4.29 kernel and a 2.6.10-1-k7 kernel from Debian
> unstable. These are the steps:
>
>     STEP 1: From a fully powered off machine, I boot into my 2.4.29
> kernel. The kernel log shows the 299 number, as well as does both
> hdparm -i and hdparm -I. No matter how many times I reboot these
> numbers maintain given I always reboot into 2.4.29.
>
>     STEP 2: I reboot into my Debian system, using 2.6.10 kernel, and
> now kernel logs show 301 number, as does hdparm -I. But hdparm -i
> shows the 299 number.
>
>     STEP 3: I reboot again into my Debian system. This time all
> places show the 301 number: the kernel logs, hdparm -i and -I.
>
>     STEP 4: I reboot into my 2.4.19 kernel, and this time ALL places,
> again, show the 301 number. No matter how many times I reboot into
> 2.4.29 again or even 2.6 (Debian), these numbers doesn't change.
>
>     I've done the same but starting from full power-off into Debian,
> and the things went like if we start from STEP 2 above. The only
> thing I've seen in the Debian logs that may explain this problem are:
>
>     current capacity is 156299375
>     native capacity is 156301488

Hard drives have a feature that can reserve a certain amount of space 
away from the user.

Linux IDE often does 'set max' to make 100% of the hard drive visible to 
the OS.

	Jeff



-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/