Dear linux gurus,
I have set up a Block Device over a SCSI drive. I write data to the
actual target drive after writing same blocks in my RAMDISK. I am
using RAMDISK of 2 GB. once the allcoated blocks of my RAMDISK are
full i start freeing those blocks (WRITE THROUGH). at this point i
get this message during Write operations
Ext2 FS- Error: ext2_new_block : Allocating blocks in System zone. <block_nr>
Is this some sort of calculation error or some other configuration problem??
--
When the going gets tough, The tough gets going...!
Peace ,
Nauman.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]