Re: Adaptec 2010S i2o + x86_64 doesn't work

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hello,

Miquel van Smoorenburg wrote:
I have a supermicro dual xeon em64t system, X6DH8-XG2 motherboard,
4 GB RAM, with an Adaptec zero raid 2010S i2o controller. In 32
bits mode it runs fine, both with the dpt_i2o driver and the
generic i2o_block driver using kernel 2.6.11.6.
In 64 bits mode however the dpt_i2o driver isn't supported, so
you have to use the generic i2o layer. But that doesn't work
either - sometimes when booting the partition table is detected,
sometimes it isn't. If it isn't, then fdisk /dev/i2o/hda works
but shows an empty disk (while there definitely are partitions
present)
In both cases doing a dd if=/dev/i2o/hda of=/dev/null crashes
the system.
According to http://i2o.shadowconnect.com/ , it should work.
I've upgraded the BIOS and firmware of the mobo and controller to
the latest versions - doesn't help. Can someone suggest what to
try next ?

Could you try out the 2.6.9 kernel, because i know that this one is working?

Also could you send me a complete output of dmesg?


Thank you very much.



Best regards,


Markus Lidel
------------------------------------------
Markus Lidel (Senior IT Consultant)

Shadow Connect GmbH
Carl-Reisch-Weg 12
D-86381 Krumbach
Germany

Phone:  +49 82 82/99 51-0
Fax:    +49 82 82/99 51-11

E-Mail: [email protected]
URL:    http://www.shadowconnect.com
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

[Index of Archives]     [Kernel Newbies]     [Netfilter]     [Bugtraq]     [Photo]     [Stuff]     [Gimp]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Video 4 Linux]     [Linux for the blind]     [Linux Resources]
  Powered by Linux