Re: Logitech MX1000 Horizontal Scrolling

[Esben Stien <b0ef@esben-stien.name>]

Esben Stien <b0ef@esben-stien.name> writes:

> can't find a single problem with the device.

I should mention a couple of things after some testing: There are some
inconsistencies with regard to cruise control.

When I press TOP CLICK BACKWARD/TOP CLICK FORWARD to cruise control
down/up, it waits about 100ms before it starts cruising. This means
that pressing a single click does not move me anywhere. I have to hold
the key down and wait until it starts cruising.

When I press HORIZONTAL LEFT/HORIZONTAL RIGHT to cruise control
left/right, it starts immediately going one step in the direction,
then waits about 100ms before it starts cruising left/right
again. This means that a single click takes me one click in the
horizontal direction.

The proper way of working in both horizontal and vertical direction
should be to start immediately going one of the directions. Also, a
single click should take me a single click in the respective
direction.

I still believe this is a kernel issue and the device should be
presented to userspace as a working device.

I'm using linux-2.6.12-rc1-RT-V0.7.41-15 with evdev and
xorg-6.8.1. (As a side note, remember to not enable radeon dri with
linux-2.6.12-rc1 as xorg will freeze)

I'll summarize my new setup:

I've turned off cruise control:

logitech_applet --disable-cc

This is my ~/.xbindkeysrc file: (yup, the whole one). Executing
xbindkeys with the -v switch yields useful debug info.

# "cruise control" disabled:
"true"
  m:0x10 + b:11
"true"
  m:0x10 + b:12

The ~/.Xmodmap file:

pointer = 1 2 3 8 9 10 11 12 6 7 4 5\n

In firefox:

mousewheel.horizscroll.withnokey.action = 0
mousewheel.horizscroll.withnokey.sysnumlines = true

Here's xorg: (I'll also setup the usb settings from Jeremy Nickurak,
but they are not important here and now).

Section "InputDevice"  # Logitech MX1000
  Identifier  "Mouse0"
  Driver      "mouse"
  Option      "Protocol" "evdev"
  Option      "Dev Name" "Logitech USB Receiver" # cat /proc/bus/input/devices
  Option      "Dev Phys" "usb-0000:00:04.2-1/input0" # cat /proc/bus/input/devices
  Option      "Device" "/dev/input/event0" # (/dev/input/mice also appears to work)
  Option      "Buttons" "12"
  Option      "ZAxisMapping" "11 12 10 9"
  Option      "Emulate3Buttons" "false"
  Option      "Resolution" "800"
  Option      "SampleRate" "800"
EndSection

I'll do a mapping of how the keys correspond to key numbers in another
followup as I'm about to leave.

-- 
Esben Stien is b0ef@esben-stien.name
         http://www.
          irc://irc.                /%23contact
          [sip|iax]:
           jid:b0ef@
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/