On Fri, 25 Mar 2005, Randy.Dunlap wrote:
> Jesper Juhl wrote:
> > Fix spelling in init/Kconfig
> >
> > Signed-off-by: Jesper Juhl <[email protected]>
> >
> > --- linux-2.6.12-rc1-mm3-orig/init/Kconfig 2005-03-25 15:29:08.000000000
> > +0100
> > +++ linux-2.6.12-rc1-mm3/init/Kconfig 2005-03-26 02:24:33.000000000 +0100
> > @@ -83,7 +83,7 @@
> > default y
> > help
> > This option allows you to choose whether you want to have support
> > - for socalled swap devices or swap files in your kernel that are
> > + for so called swap devices or swap files in your kernel that are
> > used to provide more virtual memory than the actual RAM present
> > in your computer. If unsure say Y.
>
> I would prefer (and write) "so-called".
>
I believe both "so called" and "so-called" are valid, but "so-called"
seems to be more common in the Kconfig files already. So let's be
consistent about it.
Signed-off-by: Jesper Juhl <[email protected]>
--- linux-2.6.12-rc1-mm3-orig/init/Kconfig 2005-03-25 15:29:08.000000000 +0100
+++ linux-2.6.12-rc1-mm3/init/Kconfig 2005-03-26 11:36:36.000000000 +0100
@@ -83,7 +83,7 @@ config SWAP
default y
help
This option allows you to choose whether you want to have support
- for socalled swap devices or swap files in your kernel that are
+ for so-called swap devices or swap files in your kernel that are
used to provide more virtual memory than the actual RAM present
in your computer. If unsure say Y.
--- linux-2.6.12-rc1-mm3-orig/arch/cris/arch-v10/drivers/Kconfig 2005-03-02 08:37:50.000000000 +0100
+++ linux-2.6.12-rc1-mm3/arch/cris/arch-v10/drivers/Kconfig 2005-03-26 11:35:56.000000000 +0100
@@ -836,7 +836,7 @@ config ETRAX_PA_BUTTON_BITMASK
help
This is a bitmask with information about what bits on PA that
are used for buttons.
- Most products has a so called TEST button on PA1, if that's true
+ Most products has a so-called TEST button on PA1, if that's true
use 02 here.
Use 00 if there are no buttons on PA.
If the bitmask is <> 00 a button driver will be included in the gpio
--- linux-2.6.12-rc1-mm3-orig/drivers/net/wireless/hostap/Kconfig 2005-03-25 15:28:57.000000000 +0100
+++ linux-2.6.12-rc1-mm3/drivers/net/wireless/hostap/Kconfig 2005-03-26 11:37:15.000000000 +0100
@@ -3,7 +3,7 @@ config HOSTAP
depends on NET_RADIO
---help---
Shared driver code for IEEE 802.11b wireless cards based on
- Intersil Prism2/2.5/3 chipset. This driver supports so called
+ Intersil Prism2/2.5/3 chipset. This driver supports so-called
Host AP mode that allows the card to act as an IEEE 802.11
access point.
--- linux-2.6.12-rc1-mm3-orig/drivers/mtd/chips/Kconfig 2005-03-25 15:28:49.000000000 +0100
+++ linux-2.6.12-rc1-mm3/drivers/mtd/chips/Kconfig 2005-03-26 11:37:26.000000000 +0100
@@ -160,7 +160,7 @@ config MTD_OTP
depends on MTD_CFI_ADV_OPTIONS
default n
help
- This enables support for reading, writing and locking so called
+ This enables support for reading, writing and locking so-called
"Protection Registers" present on some flash chips.
A subset of them are pre-programmed at the factory with a
unique set of values. The rest is user-programmable.
--- linux-2.6.12-rc1-mm3-orig/drivers/media/dvb/ttpci/Kconfig 2005-03-25 15:28:49.000000000 +0100
+++ linux-2.6.12-rc1-mm3/drivers/media/dvb/ttpci/Kconfig 2005-03-26 11:38:16.000000000 +0100
@@ -68,7 +68,7 @@ config DVB_BUDGET
select DVB_TDA10021
help
Support for simple SAA7146 based DVB cards
- (so called Budget- or Nova-PCI cards) without onboard
+ (so-called Budget- or Nova-PCI cards) without onboard
MPEG2 decoder.
Say Y if you own such a card and want to use it.
@@ -84,7 +84,7 @@ config DVB_BUDGET_CI
select DVB_TDA1004X
help
Support for simple SAA7146 based DVB cards
- (so called Budget- or Nova-PCI cards) without onboard
+ (so-called Budget- or Nova-PCI cards) without onboard
MPEG2 decoder, but with onboard Common Interface connector.
Note: The Common Interface is not yet supported by this driver
@@ -103,7 +103,7 @@ config DVB_BUDGET_AV
select DVB_STV0299
help
Support for simple SAA7146 based DVB cards
- (so called Budget- or Nova-PCI cards) without onboard
+ (so-called Budget- or Nova-PCI cards) without onboard
MPEG2 decoder, but with one or more analog video inputs.
Say Y if you own such a card and want to use it.
--- linux-2.6.12-rc1-mm3-orig/drivers/crypto/Kconfig 2005-03-02 08:37:45.000000000 +0100
+++ linux-2.6.12-rc1-mm3/drivers/crypto/Kconfig 2005-03-26 11:38:24.000000000 +0100
@@ -5,7 +5,7 @@ config CRYPTO_DEV_PADLOCK
depends on CRYPTO && X86 && !X86_64
help
Some VIA processors come with an integrated crypto engine
- (so called VIA PadLock ACE, Advanced Cryptography Engine)
+ (so-called VIA PadLock ACE, Advanced Cryptography Engine)
that provides instructions for very fast {en,de}cryption
with some algorithms.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
