Hi All, Kernel 2.6.35 now supports RT2860 RT2870 RT2872 RT2883 RT3070 RT3071 RT3090 RT3390 RT3572 The device will be wlan0 instead of ra0 I just downloaded http://www.kernel.org/pub/linux/kernel/v2.6/linux-2.6.35.3.tar.bz2 and built it and booted it. It found my Ralink 2860 based mini-pci and all is super-well. You will need to modify your /etc/sysconfig/wpa_supplicant and replace ra0 with wlan0 Once you do that, you will need to System->Administration->Network and activate wlan0, and save it. That should create the ifcfg-wlan0 file in /etc/sysconfig/network-scripts and should also create hard links to it in /etc/sysconfig/networking/devices and in /etc/sysconfig/networking/profiles/default (unless of course these links are no longer needed). If you had set up your wifi with a fixed ip address, you will need to set that up too. Once done, then sudo ifup wlan0 and you are up and running. I have so far discovered that these rtx00 drivers are driving the card much much better than ralinktech's own driver. For example, the signal to noise ratio is increased by a factor of 10!!! No kidding!!! Factor of 10! i.e. signal strength went from around 5 or 6 to 60!!! Enjoy. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
