"Amadeus W.M. wrote:" > > > After the raid controller verifies the DMI pool it stops, ie. I do not > > see the grub menus. I booted into rescue mode and the file systems > > appears to be good. I did a complete reinstall again and have the same > > results. > > > > > > You did make the /boot partition ext3, not ext4, right? It is ext3, I did not change the partitioning. > > I have this: a non raid disk and two mirrored disks controlled by an LSI > MegaRaid card. The system is on the non raid disk and I'm able to boot. If > I wanted to boot off of the raid array I believe I had to tell the raid > controller to make the array bootable (I believe). Not sure 100% because > I'm booting off of the non raid disk so I didn't pay much attention, I > just remember seeing that in the controller bios. Do you have to do that > on the 3Ware? No, 3Ware does not have a setting for this. > > If you have a spare disk, you may want to connect it to the motherboard, > install the system, or at least the /boot partition (as ext3) on that disk > and boot. > > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list > Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines > -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
