On Fri, May 8, 2009 at 1:49 PM, Mike Wright <mike.wright@xxxxxxxxxxxxxx> wrote:
Hi all,
This is wrt f10.
I have an 80G drive. When I installed f10 I chose a custom layout for it. My intent was to have a separate /boot partition, swap partition, and 4 lvms of approx. 20G each.
When all was said and done the drive ended up looking like this:
/dev/sda1 * 1 13 104391 83 Linux
/dev/sda2 14 2435 19454715 83 Linux
/dev/sda3 2436 4857 19454715 8e Linux LVM
/dev/sda4 4858 9964 41021977+ 5 Extended
/dev/sda5 4858 7279 19454683+ 8e Linux LVM
/dev/sda6 7280 7406 1020096 82 Linux swap / Solaris
/dev/sda7 7407 9964 20547103+ 8e Linux LVM
Certainly not what I intended.
Tried lvdisplay and got no results. Tried lvscan first then lvdisplay and got the same outcome. vgdisplay, ditto. pvdisplay, nada. fdisk seems to think there are logical volumes.
cat /etc/mtab and I see this: /dev/mapper/pdc_gdgdgcfhp1 (and 2). In fact in /dev/mapper there are 9 of these.
Anybody know where this is documented? Is lvm dead? Inquiring minds want to know ;)
Thanks for any insight,
Mike Wright
I think what you really want is one volume group and four logical volumes. I think you created 3 volume groups but perhaps someone with more LVM experience would know better.
Richard
-- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
