Hi, everyone, I cannot get my F8 system to mount my Corsair flash drive. I looked at the Forum, searched Corsair's website, and no joy. lshal finds it, and lsusb works intermittantly, finding the drive when it works, but not listing it as a drive, although lsusb seems to hang quite frequently when the drive is plugged in. DMESG says: usb 1-8: new high speed USB device using ehci_hcd and address 3 usb 1-8: configuration #1 chosen from 1 choice usb 1-8: New USB device found, idVendor=1b1c, idProduct=0ad0 usb 1-8: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-8: Product: Flash Voyager usb 1-8: Manufacturer: Corsair usb 1-8: SerialNumber: 00080221D2A41C53EE33 Initializing USB Mass Storage driver... scsi4 : SCSI emulation for USB Mass Storage devices usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usb-storage: device found at 3 usb-storage: waiting for device to settle before scanning usb-storage: device scan complete usb 1-8: reset high speed USB device using ehci_hcd and address 3 usb 1-8: device descriptor read/64, error -110 usb 1-8: device descriptor read/64, error -110 usb 1-8: reset high speed USB device using ehci_hcd and address 3 usb 1-8: device descriptor read/64, error -110 usb 1-8: device descriptor read/64, error -110 usb 1-8: reset high speed USB device using ehci_hcd and address 3 usb 1-8: device not accepting address 3, error -110 usb 1-8: reset high speed USB device using ehci_hcd and address 3 usb 1-8: device not accepting address 3, error -110 usb 1-8: USB disconnect, address 3 scsi 4:0:0:0: Device offlined - not ready after error recovery usb 1-8: new high speed USB device using ehci_hcd and address 4 usb 1-8: device descriptor read/64, error -110 usb 1-8: device descriptor read/64, error -110 usb 1-8: new high speed USB device using ehci_hcd and address 5 usb 1-8: device descriptor read/64, error -110 usb 1-8: device descriptor read/64, error -110 usb 1-8: new high speed USB device using ehci_hcd and address 6 usb 1-8: device not accepting address 6, error -110 usb 1-8: new high speed USB device using ehci_hcd and address 7 usb 1-8: device not accepting address 7, error -110 hub 1-0:1.0: unable to enumerate USB device on port 8 usb 5-2: new full speed USB device using uhci_hcd and address 2 usb 5-2: device descriptor read/64, error -110 usb 5-2: device descriptor read/64, error -110 usb 5-2: new full speed USB device using uhci_hcd and address 3 usb 5-2: device descriptor read/64, error -110 But the drive mounts and reads correctly under windows. Any ideas? Regards, Les H -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
