--- On Wed 01/25, Steven Ringwald < asric@xxxxxxxxx > wrote: From: Steven Ringwald [mailto: asric@xxxxxxxxx] To: bjhyatt@xxxxxxxxx, fedora-list@xxxxxxxxxx Date: Wed, 25 Jan 2006 16:16:28 -0800 Subject: Re: (no subject) >What does `miitool eth0` show? I have had some weird problems where >the card would get stuck in non-auto-negotiating mode, and neither >end could agree on anything.Mine says that it is in 100Mb/s Full, MII >and that a link is detected...Steve I can't find any such command. Bruce Hyatt wrote:> I am trying to get connected to the internet through Comcast highspeed and> I'm having some trouble.>> I think the problem is that the ethernet card is assigned IRQ 15 but the> driver is assigned IRQ 11. When I try to use 'ifconfig eth0 IRQ 11' it> returns 'irq: SIOCSIFMAP: Operation not supported.'>> Relevant data:>> FC2> Netinity 4500R (therefore the smp kernel)> eth0 is Intel Pro/100 (also tried Fast III 79c975)> Kernel 2.6 not updated yet> Motorola surfboard modem. (I use it for windows connection so the> connection is up.)>> I got the card to show as 'Active' the first I tried but couldn't get on> the net. Since then, it won't activate.>> ifconfig shows rx & tx with 3 errors and no drops.>>> > ( Comcast uses DHCP servers and the card must be configured to use DHCP > -- I also have Comcast-- );>> _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _>>> That's the problem. It can't obtain an IP address. It's set up to use DHCP.> _______________________________________________ No banners. No pop-ups. No kidding. Make My Way your home on the Web - http://www.myway.com
