On Fri, Dec 24, 2004 at 09:43:37PM -0500, david langton wrote: > The monitor I'm using was not detected on installation of FC3, so I edited > xorg.config to put in the horizontal and vertical frequencies and highest > resolution (1024*768). After doing this, however, system-config-display > refuses to run. I suppose this means that I need to change another config > file somewhere, but which one? I don't think system-config-display has a separate config file. When you say it refuses to run, what does it do exactly? It could be simply that you have a typo in the file. Also, with a monitor with a max resolution of 1024x768, there should be no need to edit the file by hand -- simply pick "Generic" if it's not on the list. > It might be the monitor config information that is messed up, since when I > do manage to get system-config-display to run, it doesn't allow alteration > of the monitor information (Only 'Cancel' button is enabled.) Try "system-config-display --reconfig", and pick the generic option... -- Matthew Miller mattdm@xxxxxxxxxx <http://www.mattdm.org/> Boston University Linux ------> <http://linux.bu.edu/>
