On Fri, 2004-05-21 at 20:39, Drew Bertola wrote: > I've just done a full install of FC2 (final) on a Tyan Tiger 230T (dual > PIII 800) based system. I have an Intel E100 based ethernet card and a > DLink 8139too based card. There's nothing very exotic beyond that. > > With the smp kernel, ethernet drivers load, the interfaces are > configured, and routes look good, but I can't ping out at all (I can > ping each interface). (That's with all firewalling loaded or flushed). > > Also, USB devices (mouse, cdrom, etc) are not detected and fail > completely. The only thing that shows up are the 0000:0000 devices > (hosts?). > > I had no problem with FC1 and smp, nor do I have these problems with FC2 > and a UP kernel. Additional info: I built a 2.6.6 kernel using the i686-smp config from the kernel-source rpm and that did not help at all (although it did require a whooping 1.5 GB of free hard disk space!). I think I'll look for help in the kernel list for this problem. -- Drew
Attachment:
signature.asc
Description: This is a digitally signed message part
