Re: e1000 not working after install

• To: fedora-list@xxxxxxxxxx
• Subject: Re: e1000 not working after install
• From: Daniel Roesen <dr@xxxxxxxxxx>
• Date: Sun, 9 Nov 2003 04:14:19 +0100
• In-reply-to: <[email protected]>; from [email protected] on Sun, Nov 09, 2003 at 04:01:30AM +0100
• Mail-followup-to: fedora-list@xxxxxxxxxx
• References: <[email protected]>
• Reply-to: fedora-list@xxxxxxxxxx
• Sender: fedora-list-admin@xxxxxxxxxx
• User-agent: Mutt/1.2.5.1i

On Sun, Nov 09, 2003 at 04:01:30AM +0100, Daniel Roesen wrote:
> Installing FC1 via VNC worked without problems, but now when
> using the installed system, eth0 is nonfunctional. The e1000
> driver is reporting "transmit timed out" when trying to use the
> interface.

Sorry for the noise, found the solution in the list archive.
acpi=on did the trick.


Best regards,
Daniel

• References:
  • e1000 not working after install
    • From: Daniel Roesen

• Prev by Date: Re: Minimal installation
• Next by Date: Up2date Traceback Error Message - Follow-up
• Previous by thread: e1000 not working after install
• Next by thread: Re: e1000 not working after install
• Index(es):
  • Date
  • Thread