On Sunday, 15 July 2007 09:13, Huang, Ying wrote:
> The changelog between v1 and v2
>
> 1. The kexec jump implementation is put into the kexec/kdump
> framework instead of software suspend framework. The device
> and CPU state save/restore code of software suspend is called
> when needed.
>
> 2. The same code path is used for both kexec a new kernel and jump
> back to original kernel.
>
> The complete changelog of the patch is as follow:
>
> ---
>
> Kexec base hibernation has some potential advantages over uswsusp and
> TuxOnIce (suspend2). Some most obvious advantages are:
>
> 1. The hibernation image size can exceed half of memory size easily.
In TuxOnIce (suspend2) there's no such limitation.
> 2. The hibernation image can be written to and read from almost
> anywhere, such as USB disk, NFS.
You can do this, too, with uswsusp.
> This patch implements the functionality of "jumping from kexeced
> kernel to original kernel". That is, the following sequence is
> possible:
>
> 1. Boot a kernel A
> 2. Work under kernel A
> 3. Kexec another kernel B in kernel A
> 4. Work under kernel B
> 5. Jump from kernel B to kernel A
> 6. Continue work under kernel A
>
> This is the first step to implement kexec based hibernation. If the
> memory image of kernel A is written to or read from a permanent media
> in step 4, a preliminary version of kexec based hibernation can be
> implemented.
>
> The kernel B run as a crashdump kernel in reserved memory region. This
> is the biggest constrains of the patch. It is planed to be eliminated
> in the future version. That is, instead of reserving memory region
> previously, the needed memory region is backupped before kexec and
> restored after jumping back.
>
> Another constrains of the patch is that the CONFIG_ACPI must be turned
> off to make kexec jump work. Because ACPI will put devices into low
> power state, the kexeced kernel can not be booted properly under
> it. This constrains can be eliminated by separating the suspend method
> and hibernate method of the devices as proposed earlier in the LKML.
>
> The kexec jump is implemented in the framework of kexec/kdump. In
> sys_reboot, a new command named LINUX_REBOOT_CMD_KJUMP is defined to
> trigger the jumping to (executing) the new kernel or jump back to the
> original kernel.
>
> Now, only the i386 architecture is supported. The patch is based on
> Linux kernel 2.6.22, and has been tested on my IBM T42.
>
> Usage:
>
> 1. Compile kernel with following options selected:
>
> CONFIG_X86_32=y
> CONFIG_RELOCATABLE=y # not needed strictly, but it is more convenient with it
> CONFIG_KEXEC=y
> CONFIG_PM=y
> CONFIG_KEXEC_JUMP=y
>
> 2. Compile the kexec-tools with kdump and kjump patches, the
> kdump patch can be found at:
>
> http://lse.sourceforge.net/kdump/patches/kexec-tools-1.101-kdump10.patch
>
> While, the kexec-tools kjump patch is appended with the mail.
>
> 3. Boot kernel compiled for normal usage, the reserved crash kernel
> memory region must be added to kernel command line as following:
>
> crashkernel=<XX>M@<XX>M
>
> Where, <XX> should be replaced by the real memory size and position.
>
> 4. Load kernel compiled for hibernating usage as a crashdump kernel
> with kexec, the same kernel as that of 3 can be used if
> CONFIG_RELOCATABLE=y is selected. The kernel command line option as
> following must be appended to kernel command line.
>
> kexec_jump_buf_pfn=`cat /sys/kernel/kexec_jump_buf_pfn`
>
> For example, the shell command line can be as follow:
>
> kexec -p /boot/vmlinux --args-linux --append="root=/dev/hdb signal
> kexec_jump_buf_pfn=`cat /sys/kernel/kexec_jump_buf_pfn`"
>
> 5. Boot the hibernating kernel with following shell command line:
>
> kexec -j
>
> 6. In the kexec booted kernel, trigger the jumping back with following
> shell command.
>
> kexec -j
Well, I think that's _way_ too much complicated to be useful for hibernation
on systems that are set up and administered by average users.
Greetings,
Rafael
--
"Premature optimization is the root of all evil." - Donald Knuth
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
