This patch implements a simple way of setting up per-port
flags on the SATA+PATA Promise TX2plus chips, which is a
prerequisite for supporting the PATA port on those chips.
It is based on the observation that ap->flags isn't really
used until after ->port_start() has been invoked. So it
places the "exceptional" per-port flags array in the driver's
private host structure, and uses it in ->port_start() to
finalise the port's flags.
This patch obsoletes the #promise-sata-pata branch included
in the #all branch.
Signed-off-by: Mikael Pettersson <[email protected]>
---
Changes since the RFC version:
- check cable type not ATA_FLAG_SLAVE_POSS in ->scr_read and ->scr_write
diff -rupN linux-2.6.20-rc4/drivers/ata/sata_promise.c linux-2.6.20-rc4.sata_promise-pata-20x7x-v3/drivers/ata/sata_promise.c
--- linux-2.6.20-rc4/drivers/ata/sata_promise.c 2007-01-08 20:42:55.000000000 +0100
+++ linux-2.6.20-rc4.sata_promise-pata-20x7x-v3/drivers/ata/sata_promise.c 2007-01-09 09:35:25.000000000 +0100
@@ -92,6 +92,7 @@ struct pdc_port_priv {
struct pdc_host_priv {
unsigned long flags;
+ unsigned long port_flags[ATA_MAX_PORTS];
};
static u32 pdc_sata_scr_read (struct ata_port *ap, unsigned int sc_reg);
@@ -183,7 +184,7 @@ static const struct ata_port_info pdc_po
/* board_2037x */
{
.sht = &pdc_ata_sht,
- .flags = PDC_COMMON_FLAGS | ATA_FLAG_SATA,
+ .flags = PDC_COMMON_FLAGS,
.pio_mask = 0x1f, /* pio0-4 */
.mwdma_mask = 0x07, /* mwdma0-2 */
.udma_mask = 0x7f, /* udma0-6 ; FIXME */
@@ -213,7 +214,7 @@ static const struct ata_port_info pdc_po
/* board_2057x */
{
.sht = &pdc_ata_sht,
- .flags = PDC_COMMON_FLAGS | ATA_FLAG_SATA,
+ .flags = PDC_COMMON_FLAGS,
.pio_mask = 0x1f, /* pio0-4 */
.mwdma_mask = 0x07, /* mwdma0-2 */
.udma_mask = 0x7f, /* udma0-6 ; FIXME */
@@ -271,6 +272,11 @@ static int pdc_port_start(struct ata_por
struct pdc_port_priv *pp;
int rc;
+ /* fix up port flags and cable type for SATA+PATA chips */
+ ap->flags |= hp->port_flags[ap->port_no];
+ if (ap->flags & ATA_FLAG_SATA)
+ ap->cbl = ATA_CBL_SATA;
+
rc = ata_port_start(ap);
if (rc)
return rc;
@@ -377,7 +383,7 @@ static void pdc_pata_phy_reset(struct at
static u32 pdc_sata_scr_read (struct ata_port *ap, unsigned int sc_reg)
{
- if (sc_reg > SCR_CONTROL)
+ if (sc_reg > SCR_CONTROL || ap->cbl != ATA_CBL_SATA)
return 0xffffffffU;
return readl((void __iomem *) ap->ioaddr.scr_addr + (sc_reg * 4));
}
@@ -386,7 +392,7 @@ static u32 pdc_sata_scr_read (struct ata
static void pdc_sata_scr_write (struct ata_port *ap, unsigned int sc_reg,
u32 val)
{
- if (sc_reg > SCR_CONTROL)
+ if (sc_reg > SCR_CONTROL || ap->cbl != ATA_CBL_SATA)
return;
writel(val, (void __iomem *) ap->ioaddr.scr_addr + (sc_reg * 4));
}
@@ -740,6 +746,7 @@ static int pdc_ata_init_one (struct pci_
unsigned int board_idx = (unsigned int) ent->driver_data;
int pci_dev_busy = 0;
int rc;
+ u8 tmp;
if (!printed_version++)
dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");
@@ -820,7 +827,17 @@ static int pdc_ata_init_one (struct pci_
hp->flags |= PDC_FLAG_GEN_II;
/* Fall through */
case board_2037x:
- probe_ent->n_ports = 2;
+ /* TX2plus boards also have a PATA port */
+ tmp = readb(mmio_base + PDC_FLASH_CTL+1);
+ if (!(tmp & 0x80)) {
+ probe_ent->n_ports = 3;
+ pdc_ata_setup_port(&probe_ent->port[2], base + 0x300);
+ hp->port_flags[2] = ATA_FLAG_SLAVE_POSS;
+ printk(KERN_INFO DRV_NAME " PATA port found\n");
+ } else
+ probe_ent->n_ports = 2;
+ hp->port_flags[0] = ATA_FLAG_SATA;
+ hp->port_flags[1] = ATA_FLAG_SATA;
break;
case board_20619:
probe_ent->n_ports = 4;
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
[Index of Archives]
[Kernel Newbies]
[Netfilter]
[Bugtraq]
[Photo]
[Stuff]
[Gimp]
[Yosemite News]
[MIPS Linux]
[ARM Linux]
[Linux Security]
[Linux RAID]
[Video 4 Linux]
[Linux for the blind]
[Linux Resources]
